MIP737ICS_FO_LO

The MIP737ICS2 (Integrate Circuit System) is a series of modules that integrates the electronic and hardware to support the functions of the Main Instrument Panel of B737NG simulator.
All switches, rotaries and annunciators and gauges are already installed and working, no more electronic component is needed.
The connection between the MIP737ICS2 sections are made through flat cables. MIP737ICS2 is a plug&play expansion module and requires the CPflight MCP737 ( EL or PRO/PRO2 version) to operate.
The MIP737ICS2 works with Project Magenta, Prosim737, PMDG737NGX, IFly/37 and the most common FS add-on software.
The working functions are depending by the Add-on installed software; the hardware supports all the MIP737 functionality.
The MIP737ICS2 is available in full configuration and also in partial configurations.
5 pole cable, power supply and screws to fix the modules to the structure are included.
To allow the MIP737ICS2 function, the MCP737 firmware revision has to be updated to the last version. More information about the firmware update are reported on the MCP operation manual.
MIP737ICS2 CP side is supplied with backlighted frontpanel.
Switches, rotary, annunciators, LED's and knobs are already installed and working.
The module is fully assembled with connection cables and connector to plug NOSE WHEEL STERING switch and Below G/S annunciator. Center module section is supplied with backlighted front panel.
N1 SET and SPEED REF are dual concentric Rotary switches with encoder.
Autobrake "MAX" position is guarded position so to set "MAX" pos you have to pull and rotate the knob.
Center module is provided fully assembled with the connector to plug all the flat cable that come from the other modules. All the connector have a key to avoid reversed connection. Circuit is protected by aluminium cover. MIP737ICS2 center module includes a backlighted FLAPS Gauge with 2 indipendent needles to show Left and Right position.
FO module section is supplied backlighted front panel.
Switches, rotary, annunciators, LED's and knobs are already installed and working.
FO module includes BACKLIGHTED Brake Press gauge.
Lower module section has functional single and dual concentric potentiometers.
The MIP737ICS2 is a plug&play system, no need of any configuration file or script.
You need only to connect to the MCP that will automatically reknow the modules and will start to communicate with the entire system.
The MIP737ICS2 is connected to the MCP through the 5 pole expansion socket.
Connect a plug of the enclosed 5 pole cable to one of the MIP737ICS2 sockets and the other side to the AUX socket on the back of the MCP737.
If you have other modules ( pedestal modules ) you can connect them to the second socket of the MIP737ICS2 using the BRT737DC board (daisy-chain).